Installation Instructions Bluetooth Gateway Installation InstructionsBluetooth Gateway 05
1.5 Microphone Installation
• Please see Section 1.9 for vehicle speci c Microphone mounting
positions.
• Clean surface that the microphone is to be mounted to with
alcohol and clean towel.
• Once the Microphone is mounted in the correct position, route
the cable to the Bluetooth ECU location.
• Secure the microphone cable using the supplied cable ties within
the dashboard to the existing wiring/wiring looms.
• Connect the microphone plug to the Bluetooth ECU 2.5mm
microphone socket.
• Bundle any spare microphone cable together and cable tie to the
Vehicle interface loom.
1.6 Coding the vehicle for Telephone
• Connect a vehicle diagnosis, measurement and information
system to the vehicle.
• Select the operating mode “Self Diagnosis”
NOTE: ‘X’ denotes digits in the coding which vary depending on the
vehicle
04
Head Unit Coding
The following head units require coding, if not listed here they do
not need coding.
• RNS-E Head Unit
Address 56 (Radio)
0XXX?XX- Digit marked ? Has to be changed to 7
The RNS-E head unit need to have a software index of at least
350. RNS-E RESET After coding you need to complete a RESET of
the head unit. Please turn the device off. When the head unit is
turned back on keep the ON/OFF button held down for 45 sec-
onds until the head unit resets.
• Concert 2+, Symphony 2+
Address 56 (Radio)
0?XXXXX- Add 4 to the existing value of ? (e.g. 3 to 7)
• Concert 3, Symphony 3 – only for A4 8K, A5 8T, A5 8F, Q5 8R
Address 56 (Radio)
-Select Coding
-Select master
-Select Byte 3
-Change value of Byte 3 from 10000000 to 10000010
Address 47 (Sound system)
- only for A4 8K, A5 8T, A5 8F, Q5 8R with B&O sound system
-Select Byte 3
-Set Bit 0 to 1
-Set Bit 1 to 0
Commentaires sur ces manuels