Mobridge Gateway Manuel de réparation télécharger pdf (Page 3)

Installation Instructions Bluetooth Gateway Installation InstructionsBluetooth Gateway 03

Procedure:

PLEASE NOTE:

• Installation of the Integrated Bluetooth Hands-free Phone System

should be carried out by a competent workshop. Special tools,

diagnostic equipment and special literature speci c to the car is

required for  tting.

• Incorrect installation can result in damage to the vehicle or the

product.

• After completing the installation the car must be coded for

operation with the Bluetooth system using a diagnostics,

measuring and information system

• Secure all cables and harnesses so that they cannot come into

contact with any rotating or other moving parts and so that they

cannot chafe on any sharp metal or plastic edges.

1.1 General preparation of the vehicle

for installation of the components

• Switch off the ignition and all electrical equipment

• Remove the radio/radio navigation system (refer to vehicle repair

manual)

• Remove any existing hands-free phone system that is connected

to the CANBUS wiring and do not re-install it as it will con ict with

the Bluetooth Gateway system.

1.2 Mounting the Bluetooth ECU

• Clean the underside of the Bluetooth ECU with a clean towel and

alcohol, and then attach double sided  xing tape to the underside

of the Bluetooth ECU.

• Mount the ECU with the sockets facing upwards (if ECU is to be

mounted vertically) so that the plugs cannot fall out.

• Please see pictures Section 1.8 for vehicle speci c ECU

mounting positions.

1.3 Routing the Vehicle Interface Loom

• Route the QUADLOCK Plug/Socket end of the Vehicle Interface Loom

from behind the head unit to the location of the Bluetooth ECU.

• Secure the Vehicle Interface Loom using the supplied cable ties

within the dashboard to the existing wiring/wiring looms.

1.4 Connecting the Vehicle Interface Loom

to the Radio/Radio Navigation unit.

• With the Radio/Radio Navigation unit removed, connect the

socket side of the Vehicle Interface Loom to the plug that usually

connects to the radio/radio navigation system.

• Connect the plug side of the vehicle interface loom to the radio/

radio navigation unit.

1 2 3 4 5 6 7 8 ... 30 31

Commentaires sur ces manuels

Pas de commentaire

Mobridge Gateway Manuel de réparation Page 3

Commentaires sur ces manuels

Produits connexes et manuels pour Passerelles/contrôleurs Mobridge Gateway